| Shunting operations that cover the length of Peterborough Yard and Peterborough Depot. |
 |
Getting Started:
- If you have already closed the opening message window then the first step is to pause the session by pressing the P key.
- Next locate your loco. Either:-
- Open the Finder Tool (press Ctrl F ) and type, in the Name field, the name of the loco. For example SAR T 233 (or just T 233 should be enough). Click the tick icon, OR
- Open the Driver List (bottom left of the screen) and select the loco from there - click the drivers Eye icon to jump to the loco.
- Take a few moments to get your bearings. Click
 (this link will open in this window) to show the location details and track plans for Peterborough. In each location details page:-
- the
 tab gives an overall summary of each location with a "potted" history (where available).
- the
 tab reveals the invisible  Track Marks for Drive To commands.
- the
 tab lists all active industries and their commodities.
- the
 tab describes the names, locations and settings of all junction switches as well as some switch sets you may want to use.
- Each location details page has direct links to the adjacent locations so you can explore along the route.
- When you are ready to start, reload the Peterborough Base Session page (click the Scenarios button on your current location page) and select this Scenario again or just use the Back button on your browser - whichever is quicker.
- Switch back to TRS19 Driver and either close the opening message window or press the P key to start the session.
|
|
Tutorial:
 |
A tutorial on using these scenarios is provided in the link on the left. The link will open in this window |
|
|
Yard Map: |
 |
| |
Tasks:
- Move the loco out of the Loco Depot and navigate through to the other side of Peterborough Yard onto the Stockyard road.
- Reverse onto Goods Siding 4 and attach to the rake of empty MTW flat wagons stored there.
- Move the empty wagons to the Goods Crane and load.
- Shunt the loaded wagons to Goods Siding 3 and stable.
- Move the loco to Goods Siding 5 and attach to the rake of empty Livestock wagons stored there.
- Shunt the empty wagons to the Stockyard Siding at the far end of the Stockyard road for pickup by another service.
- Move the loco back into the main depot to the Loco Depot Sidings next to the tall water tower. There are empty coal (CCC) and fuel (Tank) wagons stored on two of the siding roads.
- Shunt the two wagon sets into a single consist and stable on one of the empty Loco Depot Sidings roads for pickup by another service.
- Move the loco to the back of the workshop area at the end of the Depot Repair Storage Road .
- Attach to loco SAR T 229 (not in steam) and move it dead attached into the repair shop on Depot Repair Shop Road 2 or 3. Detach the loco.
- Return the loco to its starting position on Depot Shed Road 1.
|
 |
|
Driving Notes:
- You have permission to pass semaphore signals at stop provided you are satisfied that the road ahead is clear.
- When driving manually in yards, you are responsible for correctly setting any catch points.
|
|
|
|
This page was created by Trainz user pware in February 2021 and was last updated as shown below.
