SAR Scenario Quorn Shunter

Quorn Shunter
Shunting operations around Quorn yard.

Each location in the layout has a detailed set of track diagrams that provide the following information:-
the names of the tracks, sidings and loops the location of various facilities - stations, turntables, water columns, coal stages, engine sheds, active industries the names of active industries and their products and consumables the names and locations of trackmarks for Drive To and Drive Via commands the names, properties and locations of track switches and lists of switch sets for particular movements Enhanced Interlocking Tower paths for those locations that have EITs
To display the location data click any graphic, or go to the bottom of the page for all the session links (all links will open in this window).

Duration:

40 minutes

Loco:

SAR T 51 at Quorn Depot

Other Unrostered Locos:

Getting Started:

The first step is to pause the session by pressing the P key.
Next locate your loco. Either:-
1. Open the Finder (press CTRL-F) and type, in the name field, the name of the loco. For example SAR T 51 (or just T 51 should be enough). Click the tick icon, OR
2. Open the Driver List (bottom left of the screen) and select the loco from there - click the drivers Eye icon to jump to the loco.
Take a few moments to get your bearings. Use the (this link will open in this window) and click on Quorn to load its location details and track plans. The tab will give you the EIT Paths that are available if you wish to use them. The tab will give you the location and names of the invisible Track Marks for Drive To commands. The tab will show the names and locations of all active industries and their commodities. The tab will give the names and locations of all junction switches as well as some switch sets you may want to use.
Each location page has a direct link to the next location page, in all directions, so you can explore along the route.
When you are ready to start, reload the Peterborough Base Session page (click the Scenarios button on your current location page) and select this Scenario again or just use the Back button on your browser - whichever is quicker.
Switch back to TRS19 Driver and press the P key to start the session.

Tasks:

Move the loco from the depot and onto the Fuel Depot Siding
Collect the 4 empty Tank wagons stored in the siding and move them to eastern (Peterborough) end of the Station road.
Collect the 8 wagons Tank wagons and DB guard van stored in the Goods Sidings
Attach the 8 wagons and van to the western (Port Augusta) end of the 4 wagons on the Station road so that the DB van is at the rear (Port Augusta) end.
You can either:-
1. Terminate the scenario by moving the wagons to storage on Siding 1 and the loco back to the depot, OR
2. Begin the Quorn-Peterborough Empty Fuel Freight sceneraio starting at Step 5 (you have already completed the first 4 steps).

Driving Notes:

You have permission to pass semaphore signals at stop provided you are satisfied that the road ahead is clear.

Links: All links will open in this window
Session Scenarios List	Location List	Rolling Stock	Active Industries

This page was created by Trainz user pware in February 2021 and was last updated as shown below.