| Peterborough Shunter |
| Shunting operations that cover the length of Peterborough Yard and Peterborough Depot. |
|
 |
| Each location in the layout has a detailed set of track diagrams that provide the following information:- |
- the names of the tracks, sidings and loops
- the location of various facilities - stations, turntables, water columns, coal stages, engine sheds, active industries
- the names of active industries and their products and consumables
- the names and locations of trackmarks for Drive To and Drive Via commands
- the names, properties and locations of track switches and lists of switch sets for particular movements
- Enhanced Interlocking Tower paths for those locations that have EITs
|
To display the location data click the  graphic here or in the text below, or go to the bottom of the page for all the session links (links will open in this window). |
|
| Duration: |
1 hour |
| Loco: |
SAR T 233 on Peterborough Depot Shed Road 1
Other Unrostered Locos:
- SAR T 23 on Peterborough Depot Siding 1
|
|
|
| Yard Map: |
 |
Tasks:
- Move the loco out of the depot and navigate through to the other side of Peterborough Yard onto the Stockyard road.
- Reverse onto Goods Siding 4 and attach to the rake of empty MTW flat wagons stored there.
- Move the empty wagons to the Goods Crane and load.
- Shunt the loaded wagons to Goods Siding 3 and stable.
- Move the loco to Goods Siding 5 and attach to the rake of empty Livestock wagons stored there.
- Shunt the empty wagons to Stockyard Siding 2 DE at the far end of the Stockyard Road for pickup by a later train.
- Move the loco back into the main depot to the Depot Sidings next to the tall water tower. There are empty coal (CCC) and fuel (Tanker) wagons stored on two of the siding roads.
- Shunt the two wagon sets into a single consist and stable on one of the empty Depot Siding roads for later pickup and return to Port Pirie.
- Move the loco to the back of the workshop area at the end of the Depot Repair Storage Road.
- Attach to loco SAR T 229 (not in steam) and move it into the repair shop on Depot Repair Shop Road 2 or Depot Repair Shop Road 3. Detatch.
- Return the loco to its starting position on Peterborough Depot Shed Road 1.
|
Driving Notes:
- You have permission to pass semaphore signals at stop provided you are satisfied that the road ahead is clear.
|
This page was created by Trainz user pware in February 2021 and was last updated as shown below.
tab will give you the EIT Paths that are available if you wish to use them but they will not be needed in this scenario. The 
tab will give you the location and names of the invisible Track Marks for Drive To commands. The 
tab will show the names and locations of all active industries and their commodities. The 
tab will give the names and locations of all junction switches as well as some switch sets you may want to use.
