Quorn to Peterborough Local Freight |
A scenario in the SAR Peterborough Base Session |
A thrice weekly (if required) freight service from Quorn to Peterborough dropping wagons at locations as required. |
|
|
Duration: |
3 hours 30 minutes |
Loco: |
SAR T 232 on Quorn Goods Loop
Other Unrostered Locos:
|
Consist: |
Attached to SAR T 232. 3 MTW flat wagons, 9 QLX wagons, 2 WHE covered wagons, 2 CCC gondola wagons, 1 DB Guard Van. Each wagon has its destination as part of its name e.g. QLX Orroroo 2 indicating it is the 2nd QLX wagon for Orroroo. |
|
Each location in the layout has a detailed set of track diagrams that provide a variety of information. The Getting Started guide below gives a summary of the information that is available.
To display the data click any Line Index graphic, or go to the bottom of the page for all the session links (all links will open in this window). |
|
|
Getting Started:
- The first step is to pause the session by pressing the P key.
- Next locate your loco. Either:-
- Open the Finder Tool (press CTRL-F) and type, in the name field, the name of the loco. For example SAR T 232 (or just T 232 should be enough). Click the tick icon, OR
- Open the Driver List (bottom left of the screen) and select the loco from there - click the drivers Eye icon to jump to the loco.
- Take a few moments to get your bearings. Use the (this link will open in this window) and click on Quorn to load its location details and track plans. In each location details page:-
- the tab will identify the EIT Paths that are available if you wish to use them.
- the tab will reveal the invisible Track Marks for Drive To commands.
- the tab will show all active industries and their commodities.
- the tab will give you the names, locations and settings of all junction switches as well as some switch sets you may want to use.
- Each location page has direct links to the next locations so you can explore along the route.
- When you are ready to start, reload the Peterborough Base Session page (click the Scenarios button on your current location page) and select this Scenario again or just use the Back button on your browser - whichever is quicker.
- Switch back to TRS19 Driver and press the P key to start the session.
|
|
This page was created by Trainz user pware in February 2021 and was last updated as shown below.