How to Control Junctions in Sessions

From TrainzOnline
Revision as of 15:32, 21 June 2018 by Pware (Talk | contribs)

Jump to: navigation, search

The screenshots shown below give examples of how junction settings can be used to control the operation of a session.

Contents

Application 1: Presetting Junctions

The Scenario

When a consist reaches a trigger, the junctions ahead are set and locked into position.

Rules Used

Session Rules Screenshot

SetJunctions.JPG

Explanation

  • Line 1: Trigger Check The event is triggered when the consist reaches a trigger. This executes the following rule.
    • Line 2: Set Junctions Sets selected junctions to set directions and specifies the level of control by the users and AI.
SetJunctionsList.JPG

Application 2: Asking the User to Set Junctions

The Scenario

A consist has been halted at a trigger placed in front of a junction. The user will be asked to set that junction and the following junction before the consist can proceed.

Preconditions

Rules Used

Session Rules Screenshot

TestJunctions.JPG

Explanation

  • Line 1: Wait on Navigation Point The event is triggered when the consist halts at the navigation point assigned to the trigger. This executes the following rules simultaneously
    • Line 2: Message Popup Displays a message window asking that the next two junctions be manually set.
    • Line 3: Multiple Junction Alignment Check tests the switch directions of the next two junctions and waits until they are aligned as specified.
JunctionSettings.JPG
Checking junction switch settings

The following line is executed only if the junctions are set correctly

  • Line 4: Message Popup Displays a message window stating that the junctions are now correctly set.


Trainz Wiki

Route Creation Tutorials:

Session Creation Tutorials:

Personal tools