Help:Surveyor Topology Tools

Revision as of 00:42, 10 July 2013

The Surveyor Topology tab is where you'll find the tools used to reshape the terrain in your world.

To get started click on the Topology tab to open and close the pane (top tab, on the right edge of the screen). The three top buttons allow you to activate the basic tools to raise and lower terrain. The knobs below that alter the area the tool will affect and the sensitivity of the tool. To try it out click on the leftmost top button and then click and hold the mouse somewhere in the world. The longer you hold down the mouse the higher the terrain will get.

For more information on the various topology tools see the links below:

	Height-up tool	Increase the height of the Terrain
	Height down tool	Decrease the height of the Terrain
	Height Adjust tool	Left-click to finely adjust the the height of the Terrain up or down
	Height Radius adjustment	Adjust the size of the "circle of influence"
	Height Sensativity	Adjust the sensitivity of the "circle of influence"
	Get Height tool	Click to get the height of your Compass
	Set Height tool	Type the height you wish to apply (enter value then select Use)
	Use a Set Height tool	Apply the entered Height value to the full circle of influence
	Height Plateau tool	Apply the Height value where you left-click to the full circle of influence
	Add Water surface	Left click to paint water at the entered height.
	Set Water Height	Type the height you wish to apply (enter value then select Add)
	Move water height up/down	Left-click to finely adjust the the height of the Water up or down
	Delete Water tool	Left-click to remove water from the circle of influence
	Extend World tool	Left-click off the edge of the world to add another Trainz 'board'—a board is more land 720m X 720 metres.
	Help:Surveyor_Topology_Section_Delete	Left click to remove a section (board) of land permanently
	Advanced Button	Access advanced tools such as displacement maps and copy/paste functions

See Also

• Help:Surveyor_Tools
• Help:Surveyor