Copying Rules Between Sessions The Copy and Paste commands can be used to copy configured rules from one session to another. This saves you having to reenter the same data sets, such as driver commands, in each session. 1. in the Session Editor right mouse click on the Rule to be copied (more than one Rule can be highlighted) 2. select Copy from the popup menu 3. exit the session 4. load the second session (where the Rules are to be copied to) into Surveyor and open the Session Editor 5. right mouse click after the last rule entry and select Paste Warning: The Cut, Copy and Paste operations will NOT correctly copy ALL the settings in some rules, for example the Navigation Display Rule. It is a good idea to check the settings of each rule that you paste into the Session Editor Copying the Driver Setup Rule: The Driver Setup Rule can be copied from one Session to another using the method described above, but there are some conditions that must be met for this to work. 1. Drivers, Driver Assignments and Driver Commands ONLY are Copied. Copying the Driver Setup Rule will NOT copy the actual locomotives and consists that the drivers are assigned to. These must be copied or recreated separately 2. No Duplicate Locos Allowed - this is only an issue if you keep both the original and the copied Driver Setup Rule in the Session. If the same loco is present in both Driver Setup Rules then only the first loco (in the top copy of the rule) will be active. The duplicate loco in the second copy of the rule will be ignored 3. Missing Locos will be Ignored. If a loco is listed in the copied Driver Setup Rule but does not exist in the new Session because it was not copied across then it will be ignored Text file created 15/Feb/2020